Underside Of Roof Sheathing Is Wet

Those often are the underside of the roof.

Underside of roof sheathing is wet.

Mold on attic sheathing. This occurs when the temperature of the sheathing drops below the dew point creating a thin layer of moisture on the substrate. If the temperature drops below the freezing point often at night after the sun goes down this moisture will freeze. The presence of mold inside your home even if it.

There were also several issues with the intersection of the roofs where the 2 apartments meet. Mold growth provided it is not just cosmetic mold which can simply be left alone can be cleaned from wood surfaces by blasting scrubbing or even simple surface wiping depending on the surface accessibility and. The following picture is of a long standing moisture condition in an attic where much of the roof sheathing has turned black. Mold growing on the sheathing in your attic is a serious problem that shouldn t be ignored.

Trapped water will boil when the sun heats the roof and the shingles will then have small pits where. Does mold on attic sheathing have to be removed. In the vast majority of cases the mold growth is caused by condensation. Generally tearing off a roof and roof sheathing and perhaps roof framing to remove mold would not be sensible nor cost justified.

The osb and in fact any wood panels must be allowed to dry completely depending on how wet the panels are this could be a few days before any roofing material is applied to avoid trapping moisture under the roof material that could cause edge swell and buckling. When moisture condenses on plywood roof sheathing repeatedly or continuously the wood will turn black. The ventilation is needed not only for moisture control but also to reduce by 20 40 high summertime attic and roof sheathing temperatures which are bad for roof trusses rafters and the roof sheathing as well as the shingles and underlying waterproofing membrane which can reach 160 180 degrees over an unventilated attic. On going back inside the attic the frost had melted and the underside of the sheathing was wet not so much that it was dripping but enough that it was damp.

When this phenomenon occurs the sheathing or framing may become slightly wet on the surface. It is never a good idea to install a roof over wet plywood or any type of roof sheathing. This can be caused by the action of fungal growth and molds and the affect they have on the tannins in the wood.